Communication Between The Camera And Printer Using The Bluetooth - Sony UPX-C200 Operating Instructions Manual

Communication between the
Camera and Printer Using the
Bluetooth
For communication between the camera and printer with
Bluetooth, the followings are required:
• The same passkey set on the camera and printer
• The lamp lit
Checking the current settings
You can check the current passkey settings on the
camera and printer.
Settings on the camera
1
Display the Setup display.
For details on displaying the Setup display, see
"Displaying the Setup display" on page 34.
2
Select Bluetooth by pressing v or V of the control
button.
3
Press ENTER of the control button.
The Bluetooth display appears.
4
Select PROPERTY by pressing v or V of the
control button.
5
Press ENTER of the control button.
The Property display appears, and you can check
the passkey and address.
6
Press ENTER of the control button.
To exit the menu operation, press the MENU button.
Settings on the printer
1
Turn on the printer.
2
Press the MENU button.
3
Press V of the control button to display Bluetooth
SETTING [>>] on the operation display.
4
Press B of the control button.
The Bluetooth address appears.
5
Press V of the control button to display PASSKEY
INPUT [>>] on the operation display.
6
Press B of the control button.
The passkey currently set appears on the PASSKEY
INPUT display.
52
Bluetooth
7
Press the EXEC button.
To exit the menu operation, press the MENU button.
Changing the passkey settings
You can change the passkey as required.
On the UPX-C200 and separately available UP-DX100
Digital Photo Printer, the same passkey has been set at
the factory. For communication security, it is
recommended to change the passkey for your system.
For details on changing settings, refer to the Operating
Instructions (Advanced Operations).
If the lamp is off
If the lamp is off, the Bluetooth function is
turned off. You can activate the function following the
procedures below.
To turn on the
1
Display the Setup display
For details on displaying the Setup display, see
"Displaying the Setup display" on page 34.
2
Select Bluetooth by pressing v or V of the control
button.
3
Press ENTER of the control button.
4
Select MODULE by pressing v or V of the control
button.
5
Press ENTER of the control button.
The BT MODULE POWER display appears.
6
Check that ON is selected, then press ENTER of the
control button.
The lamp lights.
To turn on the
1
Press the MENU button.
2
Press V of the control button to display "Bluetooth
SETTING [>>]."
3
Press B of the control button.
"Bluetooth ADDR None" appears.
4
Press V of the control button to display "MODULE
POWER [>>]."
5
Press B of the control button.
lamp of the camera
lamp of the printer