Electrical; Millivolt Wiring Diagram - Pentair Pool Products MiniMax CH 150 Operation & Installation Manual

Installation (contd.)

ELECTRICAL

®
MiniMax CH Millivolt Wiring Diagram
®
MINIMAX WIRING DIAGRAM (MILLIVOLT) DUAL THERM
(HONEYWELL ELECTRONIC)
IF ORIGINAL FACTORY WIRING MUST BE REPLACED, INSTALLER MUST SUPPLY UL OR CSA (IF CANADA)
APPROVED WIRE, 18 GAUGE, 600V, 105 C˚ TEMPERATURE RATING. THERMAL FUSE WIRING MUST BE
REPLACED WITH UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 125 C˚ TEMPERATURE RATING.
INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM TO THE NATIONAL ELECTRICAL CODE OR
SUPERCEDING LOCAL (WIRING) CODES.
TH/PP
TH
GAS VALVE
WHT
ORN
WHT
THERMOSTAT BOARD
NOTE: When connecting a remote control to the MiniMax
thermostat wires in separate conduit from ANY line voltage wires. Failure to follow these
instructions will cause the thermostat relay to react
Rev. E 11-5-07
PILOT
GENERATOR
WHT
RED
PP
HI-LIMIT
SAFETY
SHUT-OFF
WHT WHT
POT 1 POT 2
SENSOR
® CH, you must install the low voltage
erratically..
PRESS
SWITCH
WHT
THERMAL
CUT-OFF
WHT
POOL
OFF
SPA
Figure 19.
17
P/N 472128