Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Premium PRBD496MS
Summary of Contents for Premium PRBD496MS
-
Page 2: Names Of The Parts
NAMES OF THE PARTS Beer Tower Plastic Gasket Safety Guard Rail Drip Tray Adjustable Thermostat Regulator Gas Cylinder Gas Cylinder Support Evaporator Reversible Door Beer Keg (not included) Metal Plate Metal Washers(2) Castors with Lock (4) -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, WARNING or injury when using your Beer Dispenser, follow these basic precautions: • Read all instructions before using the unit. • WARNING: Risk of child entrapment. • To avoid the possibility of child entrapment, please take the following precautions before throwing out the appliance. - Page 4 radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the Beer Dispenser not to perform properly. This unit is not designed for outside installation (ie garages, porches, etc.) •...
-
Page 5: Installation Instructions For Beer Keg
INSTALLATION INSTRUCTIONS FOR BEER KEG Keg Installation Sketch · Install the four castors with lock provided into the unit’s bottom (four screw holes pre-supplied) The two metal gaskets are used for the front two Castors. Figure (1) before installation. Figure (II) is the final version. - Page 6 Installation Of CO Cylinder Support • Install the metal support provided onto the 4 studs located on the exterior back wall. Align the holes in the support with the studs and push down firmly. (See Figure 1) Installation Of CO Cylinder •...
- Page 7 Installation Of The Beer Keg • Position the beer keg directly in front of the open door. Using keg handles only, carefully lift the beer keg. (See Figure 5) • To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift the front of the keg just enough so the front edge of the keg is resting on the front edge of the Beer Dispenser bottom cabinet.
-
Page 8: Dispensing Of Beer
Spanner Faucet Wrench Spanner faucet wrench is provided for either removing or tightening connection Plastic Faucet Lever Attach the black plastic lever (pull handle) to the top of the faucet by tightening it by hand clockwise until the end, holding in the silver nut underneath so it does not turn. -
Page 9: Operating Your Beer Dispenser
OPERATING YOUR BEER DISPENSER Setting The Temperature To start, turn the temperature control knob to the maximum setting (6). Allow the unit to run for 24 hours for the unit to cool properly. You may then adjust the temperature to the desired setting. In average room conditions of 70°F (21 ºC), set thermostat knob position between “4”... -
Page 10: Changing The Reversible Door
CHANGING THE REVERSIBLE DOOR This Beer Dispenser has a door that can be set to open from the left or right side. The unit is delivered to you with the door opening from the left side. To reverse the opening direction, please follow the instructions below. -
Page 11: Care And Maintenance
CARE AND MAINTENANCE Cleaning Your Beer Dispenser • Turn the temperature control to "OFF", unplug the Beer Dispenser, and remove the contents. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. •... -
Page 12: Troubleshooting Guide
TROUBLESHOOTING GUIDE You can solve many common Beer Dispenser problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. PROBLEM POSSIBLE CAUSE Beer Dispenser does not operate. Not plugged in.
Need help?
Do you have a question about the PRBD496MS and is the answer not in the manual?
Questions and answers