Characteristics - Panasonic KX-TDA600 Installation Manual

1.4.2 Characteristics

Terminal Equipment Loop Limit
Minimum Leakage Resistance
Maximum Number of Extension
Instruments per Line
Ring Voltage
Trunk Loop Limit
Hookswitch Flash/Recall Timing
Range
BRI Cards Internal ISDN Mode
Door Opener Current Limit
External Relay Current Limit
External Sensor Current Limit
Paging Terminal Impedance
MOH (Music on Hold) Terminal
Impedance
• PT: KX-T7600 series DPT: 90 W; all other DPTs/APTs: 40 W
• SLT: 600 W including set
• Doorphone: 20 W
• CS: 130 W; PT-interface CS (Basic/High-density): 65 W
15 000 W minimum
1.
for PT or SLT
2.
by Parallel or eXtra Device Port connection of an APT/DPT and
an SLT
3.
by Digital eXtra Device Port connection of 2 DPTs and an SLT
75 Vrms at 20 Hz/25 Hz depending on the Ringing Load
1600 W maximum
24 ms to 2032 ms
Supply Voltage: 40 V
Power Supply (BRI4): 4.5 W per 1 line, 10 W per 4 lines
Power Supply (BRI8): 4.5 W per 1 line, 20 W per 8 lines
Power Supply Method: Phantom Power Supply
24 V DC/30 V AC, 1 A maximum
24 V DC/30 V AC, 1 A maximum
Power to the external sensor is provided from the EIO4 card and must
be grounded through the EIO4 card. For the connection diagram, refer
to "2.8.4 EIO4 Card (KX-TDA0164)". The PBX detects input from the
sensor when the signal is under 100 W.
600 W
10 000 W
1.4.2 Characteristics
Installation Manual 35