Remote Control Unit Installation Position; Mounting On A Wall - Sanyo KHS0951 Installation Instructions Manual
Split system air conditioner
Hide thumbs
Also See for KHS0951:
- Technical & service manual (98 pages) ,
- Instruction manual (28 pages)
Table of Contents
Advertisement
7. Remote Control Unit Installation Position
The remote control unit can be operated from either a
non-fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly, do
not install the remote control unit in the following
places:
In direct sunlight
Behind a curtain or other place where it is covered
More than 26 ft. (8 m) away from the air conditioner
In the path of the air conditioner’s airstream
Where it may become extremely hot or cold
Where it may be subject to electrical or magnetic
interference
7-1. Mounting on a Wall
1) Confirm the indoor unit beeps when the
ON/OFF button is pressed at the wall location
where the remote control unit is to be attached,
then attach the holder to the wall. (Fig. 56)
2) When taking out the remote control unit, pull it
from the holder.
When using the remote control unit
•
Point the transmission portion of the remote
control unit at the receiver area of the indoor
unit when operating the remote control unit,
and during operation of the air conditioner.
•
Do not place objects that may block the trans-
mitted signals between the receiver and the
remote control unit.
When mounting the remote control unit to
prevent theft
1) Mount the holder to the wall with one of the
screws (using only the hole in the top of the
holder) (Fig. 57).
2) Remove the cover of the remote control unit
and take out the batteries. Next, place the
remote control unit in the holder.
3) Fasten both the remote control unit and holder
to the wall with the remaining screw (using the
hole in the bottom of the holder).
4) Install the batteries in the remote control unit
and close the cover.
Truss-head
tapping screw
5/32 × 5/8" (4 × 16mm supplied)
Remote
control
unit holder
Fig. 56
Truss-head
tapping screw
5/32 × 5/8" (4 × 16mm supplied)
Holder
Holder
Fig. 57
Page 22
Advertisement
Table of Contents
