Motorola DCT 2000 Owner's Manual page 43

Connecting Dolby ® 5.1, TV, VCR and A/V Receiver
1. Connect an RF cable between the cable wall outlet and the CABLE IN
connector on the DCT.
2. Connect the RF coaxial cable, supplied with the DCT, between the
RF IN and TO RF IN connectors on the DCT.
3. Connect an optical audio cable between the OPTICAL connector on the
DCT2000 and the OPTICAL connector on the A / V receiver.
4. Connect a stereo audio cable between the VCR AUDIO OUT R and L
connectors on the A / V receiver and the INPUT AUDIO R and L
connectors on the stereo VCR.
5. Connect a video cable between the VIDEO connector on the DCT
and the CABLE / TV VIDEO connector on the A / V receiver.
6. Connect a stereo audio cable between the OUTPUT AUDIO R and L
connectors on the stereo VCR and the AUDIO VCR IN R and L connectors
on the A/V receiver.
7. Connect a video cable between the INPUT VIDEO connector on the stereo
VCR and the VIDEO VCR OUT connector on the A / V receiver.
8. Connect a video cable between the OUTPUT VIDEO connector on the
stereo VCR and the VIDEO VCR IN connector on the A / V receiver.
9. Connect a video cable between the INPUT VIDEO connector on the stereo
TV and the TV / MONITOR OUTPUT VIDEO connector on the A / V
receiver.
Cable connections marked with an * are optional. These connections allow the
use of the DCT and TV without powering-on the VCR and A/V Receiver.
The optional connections are:
• Connect a RF coaxial cable between the TO TV / VCR connector on the
DCT and the CABLE / ANTENNA IN connector on the stereo VCR.
• Connect a RF coaxial cable between the To TV connector on the stereo
VCR and the CABLE / ANTENNA IN connector on the stereo TV.
When using the Dolby ® 5.1 optical output, the SPDIF and left / right
baseband audio connections to the A / V receiver are not used.
Connecting the DCT
64