Sony DCR-SR220 Operating Manual page 119

Warning indicators and messages
e
(Warning on the hard disk of the
camcorder)*
Fast flashing
• The hard disk of the camcorder is fully
recorded.
• An error may have occurred with the hard
disk drive in your camcorder.
El3
(Warning on the hard disk of the
camcorder)*
Fast flashing
• An error may have occurred with the hard
disk drive in your camcorder.
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen,
check the following.
If the problem persists even after you have
tried a couple of times, contact your Sony
dealer or local authorized Sony service
facility.
(:(or E:)
00:00
(Self-diagnosis
display)
(:04:00
• The battery pack is not an "InfoLITHIUM"
battery pack (H series). Use an
"InfoLITHIUM" battery pack (H series)
(p.94).
• Connect the DC plug of the AC Adaptor to
the DC IN jack of the Handycam Station or
your camcorder securely (p. 13).
(:13:00 I (:32:00
• Remove the power source. Reconnect it
and operate your camcorder again.
• Turn on your camcorder again.
E:20:00
I
E:31:00
I
E:61:00
I
E:62:00
I
E:91:00
I
E:94:00
• A malfunction that you cannot service has
occurred. Contact your Sony dealer or local
authorized Sony service facility. Inform
them of the 5-digit code, which starts from
«E.')
101-0001 (Warning indicator
pertaining to files)
Slow flashing
• The file is damaged.
• The file is unreadable.
~
(Battery level warning)
Slow flashing
• The battery pack is nearly used up.
• Depending on the operating environment
or battery conditions,
m
may flash, even
if there are approximately 20 minutes
remaining.
£El
(High temperature warning)
Slow flashing
• The temperature of your camcorder is
getting higher. Turn off your camcorder
and leave it for a while in a cool place.
Fast flashing*
• The temperature of your camcorder is
extremely high. Turn off your camcorder
and leave it for a while in a cool place.
I~~
(Low temperature warning)*
Fast flashing
• The temperature of your camcorder is
extremely low. Make the camcorder warm.
86