Back Panel - Honeywell Dolphin 70e Black User Manual

Hide thumbs Also See for Dolphin 70e Black:
Table of Contents

Advertisement

Back Panel

Port 1: 10/100Mbps RJ45 Ethernet Port
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-
compliant device to facilitate Ethernet communication to and from the terminal by plugging a
standard CAT-5 Ethernet cable into one of the two Ethernet ports provided. The second RJ45
Ethernet port can be used for connection to an additional device such as a printer, workstation,
eBase, or another Net Base.
Note: The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports are
used, do not connect both Net Base interfaces to the same layer 2 LAN.
Each Ethernet port has a dedicated green and yellow status LED.
Status
No Ethernet Link
10Mbps Ethernet Connection Established
100Mbps Ethernet Connection Established
Data transfer in progress
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices
and/or the Internet. For more information, see
DC Power Jack
This connector receives input from the power adapter. Plug the power connector cable from
the power adapter into this connector, see Power.
13 - 4
Yellow LED (Qty. 1 Per Port)
Port 2: 10/100Mbps RJ45 Ethernet Port
Green LED (Qty. 1 Per Port)
Yellow LED
Off
Off
On
Connection Speed Dependent
(see above)
Establishing Ethernet Communication
DC Power Jack
Green LED
Off
On
On
Flashing
on page
13-6.

Advertisement

Table of Contents
loading

Table of Contents