Important Safety Instructions; Operating Your Dehumidifier; How It Works - Haier AHD25 Use & Care Manual

When using this appliance, always exercise basic
safety precautions, including the following:
This dehumidifier must be properly
. . .
with the Installation Instructions
before it is used.
Use this appliance only for its intended purpose
as described in this Use and Care Guide.
This dehumidifier must be properly grounded
before it is used. See grounding instructions in
the Installation section.

How it works

Moist, humid air is drawn over a cold, refrigerated
dehumidifying coil. Moisture in the air condenses on
this coil and then drains into a bucket (or through a
hose into a drain). Dry, clean air is then drawn over the
condenser where it is actually heated several degrees
and discharged out the front grille into the room. It is
normal for the surrounding air to become slightly
warmer as the dehumidifier operates. This warming
effect further reduces the relative humidity of the
surrounding air.
When locating the dehumidifier, be sure to place it
where there is no restriction to the air flow either into
the coil at the rear or from the front grille. Good air
circulation through the appliance is essential to
efficient operation.
Never operate this appliance in an area that is
likely to accumulate standing water, If this
condition develops, for your safety disconnect the
power supply before stepping into the water,
Never unplug your dehumidifier by
plug firmly and pull straight out from the
receptacle.
Repair or replace immediately all electric
service cords that have become frayed or
otherwise damaged. Do not use a cord that
shows cracks or abrasion damage along its
length or at either the plug or connector end.
SAVE THESE
INSTRUCTIONS
Dehumidifying Coil
Humid "
Air In *
Drain —
r
Bucket ~
b
—- —
—
—
Appearance may vary
Condenser
Air
Air
out
Sealed
Unit
3