Thermostat Operation When Cycling Is In Effect - Honeywell SuperStat User Manual

to display heat or cool, then press the
the next usage value. The thermostat displays current usage the first time you press the usage key and
accumulated usage the next time you press the
Current day usage is automatically cleared at midnight. To clear an accumulated value, press the
until the value you want to clear is displayed and then press the
Changing a program permanently.
on page 4.
Programming Your Thermostat
Returning to normal program or start program.
program, press the
run program
key, pressing the
run program
Changing fan or system control settings.
the key, the fan status changes to the next setting. When fan is displayed, the fan is on continuously. When
nothing is displayed, the fan is in
Change the system setting by pressing the
changes to the next setting.
T O
HERMOSTAT PERATION
Normally, your thermostat operates as you programmed it. However, during the summer when the system is
in the it may not operate as you expect. Before calling for service, read the following information.
cycle mode,
While cycling is occurring, the word
the amount of time your cooling system can operate is controlled by a radio signal from Austin Energy. If
you notice the temperature in your home is higher than the setting you programmed into the thermostat,
check the thermostat display. The thermostat will display the word
cycled. You cannot control your cooling equipment when it is being cycled. When cycling stops, your
cooling equipment may not be immediately available. To prevent damage to your cooling equipment and to
allow Austin Energy to bring the equipment back on-line effectively, your thermostat automatically calculates
and initiates a time-delay before the cooling equipment comes on. You cannot override this time delay.
Replacing the thermostat batteries.
in the event of a power outage. Although the thermostat has a "low battery" indicator, replace batteries every
two years to prevent the thermostat from losing its time/date information in the event of a momentary power
outage. The first set of batteries will be provided when the thermostat is installed. As the batteries run low, the
display shows This low battery indication flashes for one or two months before the batteries run out
batlo
.
completely. Replace batteries as soon as possible after the indicator starts flashing. You will need two AA
alkaline batteries; non-alkaline batteries will not last, and can leak, causing damage to the thermostat or the
wall surface. The manufacturer and Austin Energy recommend using alkaline batteries.
Use a coin to carefully remove the battery door on the front of the unit. Press down on
To replace batteries.
the left ends of batteries to remove them and discard. Install fresh batteries. Make sure positive and negative
terminals are oriented correctly. Replace the battery door.
®
Austin Energy
key. Each time you press the
usage
key. Press the
usage
To permanently change a program, repeat the appropriate steps in
When you want to return to the normal program or start the
key. If you temporarily changed the temperature or you used the
key will cancel your change.
Change the fan setting by pressing the
(it comes on with the heating or cooling equipment as needed).
auto mode
key. Each time you press the key, the system status
system
W C I I E
HEN YCLING S N
saving is displayed on the thermostat. When cycling is occurring,
Important: Batteries must be sufficiently charged to maintain time and date
key, the thermostat displays
usage
key to stop viewing usage.
run program
key.
clear
key. Each time you press
fan
FFECT
to indicate the equipment is being
saving
6 Call toll-free at 1-877-549-2774
Usage
Run
Program
key
usage
Clear
Run
Program
Hold
hold temp
Temp
Run
Program
Fan
System