Control Settings - GE ADW1000 Series Owner's Manual

About the dishwasher control panel

Control Settings

Cycles
An indicator light above the selected pad will be ON to indicate which CYCLE has been selected, on some models.
POTS & PANS/
HEAVY WASH
(on some models)
NORMAL WASH
SHORT WASH
(on some models)
WATER SAVER
LIGHT WASH
(on some models)
RINSE ONLY
PLATE WARMER
HOT PREWASH
HOT START
CHINA CRYSTAL
(on some models)
Options
An indicator light above the selected pad will be ON to indicate which OPTION has been selected, on some models.
(on some models)
HEATED DRY
HEATED DRY
(electronic models
DELAY HOURS
(on some models)
(timer models)
START/RESET
(electronic models)
4
For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included.
This cycle will not remove burned-on foods.
NORMAL/ For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter
soil than normal. Choosing a cycle other than NORMAL WASH will save energy and water.
For quickly washing loads of everyday dishes with medium soils that have not dried on, such as loads
consisting mostly of glasses.
For dishes with light soils.
For rinsing partial loads that will be washed later. Do not use detergent.
DRYING For warming clean dishes and serving plates. This cycle will take approximately 30 minutes.
Preheats wash water to the correct temperature.
For lightly soiled china and crystal.
HI TEMP Turns on the heater in all final rinse cycles to help prevent spotting on dishware. This option may be
RINSE turned ON or OFF during the wash cycle.
HI TEMP Energizes the heater to boost water temperature in prewash and main wash fill cycles. Recommended
WASH for use with heavily soiled dishes. Option may be turned ON or OFF during the wash cycle.
Shuts off the drying heat option. Dishes air dry naturally and energy is saved. Open the dishwasher door
OFF to speed drying.
Turns the heater on for fast drying. This cycle will extend the time to your wash cycle by 30 minutes.
ON DO NOT use with RINSE ONLY cycle.
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative. You can lock the controls to
prevent any selections from being made. Or you can lock the controls after you have started a cycle or selected
DELAY START so the cycle or DELAY START is not interrupted.
only)
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice within 3 seconds. The light above
the LOCK pad will turn off.
Delays the start of a wash cycle for up to 8 hours.
RESET Touch RESET to cancel options.
Touch START/RESET one time to start dishwasher cycle. Touch START/RESET a second time to pump out
and then turn off the dishwasher. Do not touch START/RESET more than one time unless you intend to
end the cycle.