Base Enclosure - HP EliteBook 840 G2 Notebook PC Maintenance And Service Manual

Base enclosure

Description
For use only on HP EliteBook 840 G2 Notebook PC and HP EliteBook 740 G2 Notebook PC
computer models
For use only on HP ZBook 14 G2 Mobile Workstation computer models
Before removing the base enclosure, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
5. Remove the battery (see
6. Remove the keyboard (see
Remove the base enclosure:
1. Close the computer.
2. Position the computer upside down with the rear panel toward you.
3. Remove the eight rubber screw covers.
The base enclosure rubber screw covers are included in the Rubber Kit, spare part number 730796-001
ENWW
Service cover on page
Battery on page 53).
Keyboard on page 63).
51).
Component replacement procedures
Spare part number
779684-001
795946-001
75