Using The Built-In Temperature Sensor On The Remote Controller - Mitsubishi Electric PURY-P72 Service Handbook

- - - - - - - - - - -
--
- - - - - - - - - - - - - -
- - -
[IV Remote Controller
1
< 2. Search Procedures>
@To search for the LOSSNAY unit that is interlocked with a particular indoor unit, enter the address of the indoor unit into the remote controller that is
connected to it.
J-!-
<Indoor unit address>
@Press the [E!) MENU} button to search
for
the address of the LOSSNAY
unit
that is interlocked with the selected indoor unit.
- Search completed (With a LOSSNAY connection)
The indoor unit address and" IC;' and the interlocked LOSSNAY address and "LC" will appear alternately.
/[J-I-~
'-----'---=--'---'
- Search completed (No interlocked settings with a LOSSNAY eXist.)
-e~l-
- The selected address does not have a corresponding indoor unit.
-'B8;-~-I-
/ j
'er--
< 3. Deletion Procedures>
Take the following steps to delete the interlock setting between a LOSSNAY unit and the interlocked indoor unit from the remote controller
that is connected to the indoor unit.
@Find the address of the LOSSNAY to be deleted (See section 2. Search Procedures.), and bring up the result ofthe search for both the
indoor unit and LOSSNAY
on
the display.
~~::;-----:;;:~---,
3uW-
88
.
88}-1-~
L.-_ _
- ' - - _ ~ - - ' - _ . J
-Deletion error
If the deletion fails
[4] Using the built-in Temperature Sensor on the Remote Controller
1. Selecting the position of temperature detection (Factory setting: 5W1-1 on the controller board on the indoor unit is
set to OFF.)
To use the built-in sensor on the remote controller, set the SW1-1 on the controller board on the indoor unit to ON.
-Some models of remote controllers are not equipped with a built-in temperature sensor. Use the built-in temperature sensor
on the indoor unit instead.
-When using the built-in sensor on the remote controller, install the remote controller where room temperature can be detected.
HWEOB03A - 89-
GB