USING AC ADAPTOR
Insert the 15V DC plug (Fig. 4) of AC adaptor into the 15V DC socket (Fig. 3), and then plug the AC pins (Fig. 4)
into a main power supply. Make sure that the voltage rating of the main power supply corresponds with that of the
To operate the cordless fan, first you need push the power switch button (1 in Fig. 1) to turn on the fan, now the fan
starts to work on high speed mode. If you want to change to low speed mode, push the speed change button ( in
Fig. 1-1) and the speed indicator will show on low speed mode.
Push the power switch button (1 in Fig. 1) to turn off the unit after you finish using, then unplugged the AC adaptor
from the main power supply, and allow the cordless fan to cool completely before performing any inspection,
maintenance, cleaning procedures or storage.
SAVE THESE INSTRUCTIONS
It may delay – 5s to start after the adaptor being inserted.
The adaptor might creak while using it for the power supply. This doesn't affect normal use.
USING BATTERY CARTRIDGE
IN ORDER TO ENSURE THE BATTERY MAXIMUM PERFORMACE, IT IS RECOMMENDED THAT THE BATTERY
CARTRIDGE SHOULD BE CHARGED BEFORE BEING USED FOR THE FIRST TIME.
Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, () battery,
and () product using battery.
Do not disassemble battery cartridge.
If operating time has become excessively shorter, stop operating immediately. It may result in a risk of
overheating, possible burns or even an explosion.
If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may
result in loss of your eyesight.
Do not shorten the battery cartridge:
(1) Do not touch the terminals with any conductive material.
() Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.
() Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow, overheating, possible burns and even a breakdown.
Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (1°F).
Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery
cartridge can explode in a fire.
Be careful not to drop or strike battery.
Do not use a damaged battery.
SAVE THESE INSTRUCTIONS
Tips for maintaining maximum battery life:
Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery
cartridge when you notice less tool power.
Charge the battery cartridge with room temperature at 10°C – 0°C (50°F – 10°F). Let a hot battery cartridge
cool down before charging it.
Charge the battery cartridge once in every six months if you do not use it for a long period of time.
Installing or removing of battery cartridge
Always switch off the tool before installing or removing of the battery cartridge.
To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into
place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side
of the button, it is not locked completely. Install it fully until the red part can not be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone around you.
Do not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being
To operate the cordless fan using battery cartridge, please refer to the instruction of AC adaptor.
The portable fan can set a run time for 1 hour, hours, or hours by the timer switch (5 in Fig. 1-1).
The number underneath the LED shows the remaining hour for turn off.
The cordless fan may run less time than the time you set when you use the battery cartridge.
The portable fan base can be set in a variety of positions. To switch base positions, adjust base to desired position.