1-Way Cassette - LG ARNU073TUC4 Instruction Manual

1-Way Decoration Panel Installation
1. Install two decoration panel attaching screws on the cassette chassis. Tighten about
3/8 inch.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air
inlet grille cord.)
3. Hook the decoration panel key hole on the screws installed,
and slide the panel so that the screws reach
the key hole edge.
4. Tighten completely the two initially installed
screws and two additional screws.
5. Connect the louver motor connector and
display connector.
6. After tightening these screws, install the air
inlet grille (including the air filter)
INSTALL DECORATION PANEL
Piping side
Filter
Safety grille
Louver motor
Push
Decorative panel
Ratch pull
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 33: Decoration Panel Installation
Inlet Grille In le t G rille

1-Way Cassette

Attaching screws
Control box cover
Cover
Key holes
Decorative panel
fixing screws
(Hexagon M6 screw)
49