Interlock Settings Via The Ma Remote Controller - Mitsubishi Electric PUHY-HP200 Service Handbook

[ IV Remote Controller ]

[3] Interlock Settings via the MA Remote Controller

1. LOSSNAY interlock setting (Make this setting only when necessary.)
Make this setting only when necessary.
Perform this operation to enter the interlock setting between the LOSSNAY and the indoor units to which the remote controller is connected, or to
search and delete registered information.
In the following example, the address of the indoor unit is 05 and the address of the LOSSNAY unit is 30.
[Operation Procedures]
Press the [ON/OFF] button on the remote controller to bring the unit to a stop.
1
The display window on the remote controller must look like the figure below to proceed to step
Press and hold the [FILTER] and [
2
indoor unit to which the remote controller is connected.
Search result
3
- The indoor unit address and the interlocked LOSSNAY address will appear alternately.
<Indoor unit address and indoor unit>
- Without interlocked LOSSNAY settings
If no settings are necessary, exit the window by pressing and holding the [FILTER] and [
4
Go to step 1. Registration Procedures to make the interlock settings with LOSSNAY units, or go to step 2. Search Procedures to search for a
particular LOSSNAY unit.
Go to step 3. Deletion Procedures to delete any LOSSNAY settings.
< 1. Registration Procedures >
5
To interlock an indoor unit with a LOSSNAY unit, press the [ TEMP. (
unit, and select its address (01 to 50).
6
Press the [ CLOCK ( ) or (
Indoor unit address LOSSNAY address
Press the [TEST] button to register the address of the selected indoor unit and the interlocked LOSSNAY unit.
7
- Registration completed
The registered indoor unit address and IC, and the interlocked LOSSNAY address and LC will appear alternately.
- Registration error
If the registration fails, the indoor unit address and the LOSSNAY address will be displayed alternately.
Registration cannot be completed: The selected unit address does not have a corresponding indoor unit or a LOSSNAY unit.
Registration cannot be completed: Another LOSSNAY has already been interlocked with the selected indoor unit.
HWE08110
] buttons simultaneously for two seconds to perform a search for the LOSSNAY that is interlocked with the
<LOSSNAY address and LOSSNAY>
)] button to select the address of the LOSSNAY to be interlocked (01 to 50).
.
2
] buttons simultaneously for 2 seconds.
) or ( )] button on the remote controller that is connected to the indoor
- 60 - GB