Troubleshooting; Specifications - Sony CDP-M333ES Operating Instructions Manual

Compact disc player
Hide thumbs Also See for CDP-M333ES:
Table of Contents

Advertisement

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
,Check that the player is connected securely.
,Make sure you operate the amplifier correctly.
The CD does not play.
,There's no CD inside the player ("–NO DISC–"
appears). Insert a CD.
,Insert the CD with the label side facing right.
,Clean the CD (see page 34).
,Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 34).
The remote does not function.
,Remove obstacles in the path of the remote and
the player.
,Point the remote at the remote sensor
player.
,Be sure to set up the remote correctly.
,Replace all the batteries in the remote with new
ones if they are weak.
,Set the command mode of the remote according
to the command mode of the player.
The player functions incorrectly.
,The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
Downloaded From Disc-Player.com Sony Manuals

Specifications

Compact disc player
Laser
Laser output
Frequency response
Dynamic range
Harmonic distortion
Output
Jack
type
LINE OUT
Phono
jacks
DIGITAL OUT
Optical
(OPTICAL)
output
connector
on the
General
Power requirements
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Additional Information
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ±0.5 dB
More than 95 dB
Less than 0.003%
Maximum
Load
output
impedance
level
2 V
Over 10 kilohms
(at 50 kilohms)
–18 dBm
Wave length: 660 nm
120 V AC, 60 Hz
20 W
430 × 189 × 537 mm
(17 × 7 1/2 × 21 1/4 in.) incl. projecting
parts
9.5 kg (20 lbs 16 oz.)
35

Advertisement

Table of Contents
loading

Table of Contents