Troubleshooting; Installation - AEG HC412000GB User Manual

7. TROUBLESHOOTING

There is no spark when
lighting the gas
The flame is blow out im-
mediately after ignition
The gas ring burns un-
evenly
If there is a fault, first try to find a solu-
tion to the problem yourself. If you can-
not find a solution to the problem your-
self, speak your dealer or the local Serv-
ice Force Centre.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Problem
Qn (Hs): 4.9 kW
Made in Switzerland
Butan: 350 g/h
AC 220-240 V 50/60 Hz
10
P<0,025 kW
0063
Adjusted for: G20 2H 2E 2E - 20 mbar
PIN 0063CL3451
Typ: 55 FED 04 GA
Possible cause
• There is no electrical
supply
• Burner cap and crown
are placed uneven
• Thermocouple is not
heated sufficient
• Burner crown is
blocked with food resi-
dues
Remedy
• Make sure that the
unit is connected and
the electrical supply is
switched on.
• Control the fuse. If the
fuse is released more
than one time, refer to
a qualified electrician.
• Make sure that the
burner cap and crown
are in correct posi-
tions.
• After lightning the
flame, keep the knob
pushed for approxi-
mately 5 seconds.
• Make sure that the in-
jector is not blocked
and the burner crown
is clear of food parti-
cles.
If you operated the appliance in-
correctly, or the installation was
not carried out by a registered
engineer, the visit from the cus-
tomer service technician or deal-
er may not take place free of
charge, even during the warranty
period.
Before the installation, note
down the serial number (Ser. Nr.)
from the rating plate.The rating
plate of the appliance is on its
lower casing.
PNC: 941 560 810/00
Serie-Nr:
Mod.: HC412000GB
ENGLISH
53