Connecting The Ac Cord; Turning The Power On; To Dim The Display - Sharp SD-WH1000U Operation Manual

Before Starting Playback
AC cord

Connecting the AC Cord

1 Plug the supplied AC cord into the AC IN terminal
on the rear of the Player.
2 Then, plug into an AC outlet with ground hole.
NOTE
• Place the Player close to the AC outlet, and keep the
power plug within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
• If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from the AC outlet.

Turning the Power On

POWER/POWER
(ON/STANDBY) indicator
Turning the power on
Press POWER to turn on the power of the Player.
• The POWER indicator lights blue.
NOTE
• To change language, please see the language setting
(see page 52).
• When you turn on this player, the WiSA system is
automatically started if "Audio Out" is selected at "WiSA
Output" on page 44.
• If any associated WiSA-compliant receivers and speakers
are not found, an alert message of "A registered receiver
is not found" will be displayed on the screen.
AC cord
WiSA indicator
Entering standby
Press POWER to enter standby.
• The POWER indicator lights red.
• If you press POWER again immediately after entering
standby, the Player may not turn on. If this happens, wait
for 10 seconds or more and then turn on the power again.
• Week electric power is still consumed even when the
player is turned off.
NOTE
• When you turn off the Player, the WiSA system will
automatically stop.
Indicators on the Player
POWER (ON/STANDBY) indicator
Blue on
Red on
NOTE
• The POWER indicator blinks while the Player is preparing
for starting up. You cannot turn the Player on until the
POWER indicator stops blinking.
WiSA indicator
Blue on

To Dim the Display

If you feel that the front panel display and indicator
on the player are too bright when watching movies,
you can dim the front panel display except for the
POWER indicator.
DIMMER Front panel display
Press DIMMER to turn the front panel display and
indicator is turned Dimmer1, Dimmer2, Dimmer3 or
OFF (see page 52).
29
Power on
Standby
WiSA System On mode
(When "Audio Out" is
selected at "WiSA Output"
on page 44).