Before Starting Playback; Loading The Batteries In The Remote Control; Remote Control Code Setting - Sharp SD-WH1000U Operation Manual

Wireless universal player
Table of Contents

Advertisement

Available languages

Available languages

Before Starting Playback

"AA" size battery (x2)
Loading the Batteries in the
Remote Control
1
Remove the battery cover towards the direction
of the arrow.
2
Load the two "AA" size batteries (R-06 size, UM/
SUM-3). Place batteries with their terminals
corresponding to the m and n indications in
battery compartment.
3
Insert the tab of the battery cover, and close the
cover until it clicks.
NOTE
• Do not subject the remote control unit to shock, water or
excessive humidity.
• The remote control unit may not function if the Player's
remote sensor is in direct sunlight or any other strong
light.
• Incorrect use of batteries may cause them to leak or
burst. Read the battery warnings and use the batteries
properly.
• Do not mix old and new batteries, or mix different brands.
• Remove the batteries if you will not use the remote
control unit for an extended period of time.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
Approximate operating range of
remote control
Remote control sensor
15º
3
º 0
15º

Remote Control Code Setting

This player can respond to one of three sets of
remote control codes. If you have other SHARP
products in the vicinity of this player, the other
products may respond to this player remote control.
To prevent this, you can select a different remote
code.
If you have selected a new remote code on the
player, you must set the remote control handset to
use the same code (see page 52).
• Hold down the 1, 2, or 3 button and press ENTER for at
least 5 seconds. (Select the same number as selected on
the Player.)
NOTE
• If the batteries in the remote control unit are exhausted,
or when you change the batteries, the remote control
number may revert to 1.
26
3
º 0
c Remote control unit
* Approx. 20 feet (6 m)
from the sensor

Advertisement

Chapters

Table of Contents
loading

Table of Contents