Bosch GTS 10 J Professional Original Instructions Manual page 28

OBJ_BUCH-1325-001.book Page 48 Saturday, January 22, 2011 12:54 PM
48 | English
Adjusting:
– Loosen Allen screws 59 at the front below
the saw table and Allen screws 60 at the rear
below the saw table with the supplied Allen
key 21.
– Carefully move the saw blade until it is paral-
lel to guide groove 5.
– Retighten all screws 59 and 60 again.
Adjusting the Saw Table's Clearance Indicator
(see figure V)
– Position the parallel guide on the right side
of the saw blade.
Move the parallel guide until the mark in the
lens 27 indicates 26 cm on the bottom scale.
To lock the parallel guide, press clamping
handle 35 down again.
– Loosen tensioning lever 15 and pull the table
extension out to the stop.
Checking:
On the upper scale 1, clearance indicator 51
must indicate the identical value as the mark in
lens 27 on the bottom scale 1.
Adjusting:
– Loosen screw 61 with a Phillips screwdriver
and align clearance indicator 51 alongside
the 26 cm mark of the upper scale 1.
1 609 929 X56 | (22.1.11)
Adjusting the Lens of the Parallel Guide
(see figure W)
– Bring the power tool into the working posi-
tion.
– Tilt the protection guard 6 toward the rear to
the stop.
– Move parallel guide 10 from the right until it
touches the saw blade.
Checking:
The mark of lens 27 must be in a line with the 0°
mark of scale 1.
Adjusting:
– Loosen screw 62 using a Phillips screwdriver
and align the clearance indicator alongside
the 0° mark.
Adjusting the Level of the Insert Plate
(see figure X)
Checking:
The front side of the insert plate 24 must be
flush with or somewhat lower than the saw ta-
ble; the rear side must be flush with or some-
what above the saw table.
Adjusting:
– Remove the insert plate 24.
– Adjust the correct level of the four adjusting
screws 63 with the Allen key 64.
Bosch Power Tools