Delivery Scope - Bosch GTS 10 J Professional Original Instructions Manual

OBJ_BUCH-1325-001.book Page 41 Saturday, January 22, 2011 12:54 PM
Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.

Delivery Scope

Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Table saw with mounted saw blade 26 and
riving knife 25
– Angle stop 3
– Profile rail 28
– Fastening kit "profile rail" 40 (guide plate,
knurled nut, screw, washer)
– Parallel guide 10
– Auxiliary parallel guide 37
– "Auxiliary parallel guide" fastening kit 38 (3
fastening screws, 3 washers, 3 wing nuts)
– Blade guard 6*
– Allen key 21
– Allen key 64
– Ring spanner 22
– Push stick 23
– Insert plate 24
– Extraction adapter 32
(* depending on country version)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Bosch Power Tools
Mounting Individual Components
– Carefully remove all parts included in the de-
livery from their packaging.
Remove all packaging material from the ma-
chine and the accessories provided.
– Take care that the packaging material under
the motor block es removed.
The following product features are fastened di-
rectly to the housing:
Push stick 23, ring spanner 22, allen key 21 and
64, parallel guide 10, angle guide 3, extraction
adapter 32, auxiliary parallel guide 37 with fas-
tening kit 38, blade guard 6.
– Carefully remove these product features
from their storage locations.
Also see figures Y1–Y6.
Mounting the Insert Plate (see figure A)
– Hook insert plate 24 into the rear insert-plate
notches 34 of the tool basin.
– Guide the insert plate down.
– Press on the insert plate until it engages at
the front in the tool basin.
The front side of the insert plate 24 must be
flush with or somewhat lower than the saw ta-
ble; the rear side must be flush with or some-
what above the saw table. (also see "Adjusting
the Level of the Insert Plate", page 48)
Mounting the Blade Guard (see figure B)
– Turn crank 19 clockwise to the stop, so that
the saw blade 26 is in the highest possible
position above the saw table.
– Pull the riving knife 25 upward to the stop.
– Insert the blade guard 6 into the recess in riv-
ing knife 25.
– Tighten the clamping lever 8.
The clamping force must be adjusted in such
a manner that the blade guard can always be
aligned according to the height of the work-
piece.
1 609 929 X56 | (22.1.11)
English | 41