Motorola FR68 Series User Manual page 126

Troubleshooting the FR68 Series (Continued)
Table 9-1
Problem
Battery is
FR68 Series shuts
over-temperature.
off.
Tapping the Screen is not calibrated
window buttons or correctly.
icons does not
activate the
corresponding
feature.
A message Too many files stored on
appears stating the FR68 Series.
that the FR68
Series memory is
Too many
full.
applications
installed on the
FR68 Series.
The FR68 Series'
FR68 Series
keeps powering battery is low.
down to protect
The internal Bluetooth
memory contents.
radio is powered on
for a long time.
The FR68 Scanning application
Series does not is not loaded.
accept scan
input.
Unreadable bar
code.
Distance between exit
window and bar code is
incorrect.
FR68 Series is not
programmed for the bar
code.
FR68 Series is not
programmed to
generate a beep.
Battery is low.
Cause Solution
Battery temperature >40℃( 104°F ) or <-10℃ (14°F)
Re-calibrate the screen. See
Page 20.
Delete unused memos and records. If necessary,
save these records on the host computer (or use an
SD card for additional memory).
Remove user-installed applications on the FR68 Series to
recover memory. Select
and tap the
program and tap Remove.
Recharge the battery.
Because this mode requires battery power, power it off
when not needed.
Load a scanning application on the FR68 Series.
See the system administrator.
Ensure the symbol is not defaced.
Place the FR68 Series within proper scanning range.
Program the FR68 Series to accept the type of bar code
being scanned.
If the FR68 Series does not beep on a good decode, set
the application to generate a beep on good decode.
If the scanner stops emitting a laser beam upon a trigger
press, check the battery level. When the battery is low,
the scanner shuts off before the FR68 Series low battery
condition notification. Note: If the scanner is still not
reading symbols, contact the distributor or Zebra.
124
Maintenance & Troubleshooting
Calibrating the Screen on
>
Start Settings
icon. Select the unused
Remove Programs
> tab
System