Installation; Mounting The Thermostat To The Wall - Verdant V8-BB-7S Instruction Manual

INSTALLATION

Mounting the Thermostat to the Wall

BEFORE YOU BEGIN
Turn off all heating equipment by switching off the power
supply located at the electrical service panel.
All heating equipment should be OFF.
1. Remove the old thermostat from the wall and
disconnect wires from the old thermostat.
2. Using the wire connectors provided, connect
the wires to your new thermostat. The
thermostat wires are not polarized and can
be connected to either of the two (2) wires
from the electric box in the wall.
If there are four (4) wires coming out the
electric box in the wall, use a solderless wire
connector (not supplied) to join one load
wire from the electric box to one power
supply wire from the electric box and then
connect the remaining two (2) wires to the
thermostat.
If you are unable to identify the load and
power supply wires correctly, consult
with an electrician. Incorrectly wiring
your thermostat can cause severe
damage to the thermostat.
3. Mount your new thermostat to the wall
using the supplied mounting screws. Use
either the two holes on the right or the left
side depending on the desired positioning.
4. Plug four (4) mounting-screw holes with
supplied screw covers.
5. If you wish, apply the supplied instructions
sticker onto the left thermostat panel.
- 4 -
INSTALLATION
Mounting the Thermostat to the Wall
Use the provided wire connector caps to connect
the thermostat wires with the wires from the electrical box.
The thermostat wires are not polarized and can be connected
to either of the wires from the wall (load or power supply).
Mount the thermostat onto the electrical box in the wall
using the supplied mounting screws.
Use either the two holes on the right or the left side
depending on the desired positioning.
- 5 -