Remote Access - Acorp Sprinter W422G User Manual

Destination IP
Destination Netmask
Protocol
Source Port
Destination Port
Physical Port
Fields on the second setting block of this page:
Field
Outbound Priority
IP Precedence
IP Type of Service
802.1p

4.5.6 Remote Access

The IP address of the traffic destination.
The destination IP netmask. This field is required if the destination IP has been
entered.
The selections are TCP, UDP, ICMP and the blank for none. This field is required if
the source port or destination port has been entered.
The source port of the selected protocol. You cannot configure this field without
entering the protocol first.
The destination port of the selected protocol. You cannot configure this field without
entering the protocol first.
The incoming ports. The selections include LAN ports, wireless port, and the blank
for not applicable.
Description
The priority level for the traffic that matches this classification rule. The possible
selections are (in the descending priority): p0, p1, p2, p3.
Select this field to mark the IP precedence bits in the packet that match this
classification rule.
Select this field to mark the IP TOS bits in the packet that match this classification
rule.
Select this field to mark the 3-bit user-priority field in the 802.1p header of the packet
that match this classification rule. Note that this 802.1p marking is workable on a
given PVC channel only if the VLAN tag is enabled in this PVC channel.
55