Contents Safety information Care and cleaning Operation What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice Safety information In the interest of your safety and to ensure ance.
Page 3
Warning! Any electrical component • Regularly examine the drain in the refrig- (power cord, plug, compressor) must erator for defrosted water. If necessary, be replaced by a certified service agent clean the drain. If the drain is blocked, or qualified service personnel to avoid water will collect in the bottom of the ap- hazard.
Environment Protection ance shall be disposed according to the applicable regulations to obtain This appliance does not contain gasses from your local authorities. Avoid dam- which could damage the ozone layer, aging the cooling unit, especially at the in either its refrigerant circuit or insula- rear near the heat exchanger.
For more thorough cleaning, the top and bottom door shelves can be easily removed and refitted in position Positioning the door shelves The model is equipped with a variable stor- age box which is fitted under a door shelf compartment and can be slide sideways. Helpful hints and tips Normal Operating Sounds allow automatic defrosting and so a sav-...
Milk bottles: these should have a cap and Bananas, potatoes, onions and garlic, if not should be stored in the bottle rack on the packed, must not be kept in the refrigera- door. tor. Care and cleaning Caution! Unplug the appliance before every time the motor compressor stops, carrying out any maintenance during normal use.
What to do if… Warning! Before troubleshooting, Important! There are some sounds during disconnect the mains plug from the normal use (compressor, refrigerant mains socket. circulation). Only a qualified electrician or compe- tent person must do the troubleshoot- ing that is not in this manual. Problem Possible cause Solution...
Problem Possible cause Solution There is no cold air circulation in Make sure that there is cold air the appliance. circulation in the appliance. Replacing the lamp 1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cov- 3.
The appliance must be earthed. The power Climate Ambient temperature supply cable plug is provided with a contact class for this purpose. If the domestic power sup- +10°C to + 32°C ply socket is not earthed, connect the appli- +16°C to + 32°C ance to a separate earth in compliance with current regulations, consulting a qualified +16°C to + 38°C...
Need help?
Do you have a question about the IKE1660-1 and is the answer not in the manual?
Questions and answers