Side/Rear Panel - Sony LMD-3250MD Instructions For Use Manual

Side/Rear Panel

qs
qd
qf
qg
qh
a DC 5V/24V IN connector
Connect the DC connector of the supplied AC adaptor.
b
/ (power) switch
The power is turned on or off.
The monitor is turned on by pressing side
c Loop-through output connectors
Outputs the signals input to the input connectors (5 to
0). Connect to the analog input (composite, Y/C,
analog component, analog RGB or external sync) of
equipment, according to the input signal.
When a cable is connected to one of these connectors,
the 75-ohm termination of the corresponding input is
automatically released, and the signal input to the input
connector is output.
d
/I (Equipotential/Function Earth) terminal
(equipotential) terminal
Connects the equipotential plug.
I (function earth) terminal
Connects the earth cable.
e G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
qa
IN G/Y OUT
5
IN B/P OUT
B
6
IN R/P OUT
R
7
EXT
IN OUT
SYNC
8
Y/C
IN OUT
9
COMPOSITE
IN OUT
0
.
+24V
DC
5V24V IN +5V
1
2
3
4
f B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
g R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
h EXT SYNC IN (external sync input) connector
(BNC)
When this unit operates on an external sync signal,
connect the reference signal from a sync generator to
this connector.
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
Note
When inputting a video signal with the jitters, etc. the
picture may be disturbed. We recommend using the
TBC (time base corrector).
i Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
j COMPOSITE IN connector (BNC)
Input connector for composite signals.
Location and Function of Parts and Controls
(blue color
B
(red color
R
53