Using Your Projector; Turning Your Projector On; Turning Your Projector Off - Dell S510 User Manual

3

Turning Your Projector On

NOTE:
Turn on the projector before you turn on the source
(computer, DVD player, etc.). The Power button light blinks white
until pressed.
Connect the power cord and appropriate signal cables to the projector.
1
For information about connecting the projector, see "Connecting Your
Projector" on page 9.
Press the Power button (see "Using the Remote Control" on page 29 to
2
locate the Power button).
Turn on your source (computer, DVD player, etc.)
3
Connect your source to the projector using the appropriate cable. See
4
"Connecting Your Projector" on page 9 for instructions to connect your
source to the projector.
By default, the input source of the projector is set to VGA-A. Change the
5
input source of the projector if necessary.
If you have multiple sources connected to the projector, press the Source
6
button on the remote control to select the desired source. See "Using the
Remote Control" on page 29 to locate the Source button.

Turning Your Projector Off

CAUTION:
explained in the following procedure.
Press the Power button. Follow the instruction displayed on screen to
1
properly turn off the projector.
NOTE:
The "Press Power Button to Turn off Projector" message
will appear on the screen. The message disappears after 5 seconds
or you can press the Menu button to clear it.
Press the Power button again. The cooling fans continue to operate for
2
120 seconds.
To power off the projector quickly, press the Power button and hold for 1
3
second while the projector's cooling fans are still running.

Using Your Projector

Unplug the projector after properly shutting down as
Using Your Projector 25