Wash/Rinse Temperature; Rinse Hold - LG WD-3274RHD Owner's Manual

H ow to use washer

WASH/RINSE TEMPERATURE.

• Press TEMP. to cycle through
the temperature choices.
DRY ONLY
• Select a water temperature
EXTRA RINSE
based on the type of load you
EXTRA WASH
are washing. Use the warmest
water safe for fabrics. Follow
OPTION
garment label instructions.
• Warm rinses leave the loads
dryer than cold rinses. Warm
rinses increase wrinkling. In cold
climates, a warm rinse makes the load mere
comfortable to handle. Cold rinses save energy.
• Warm rinses are regulated at approximately 75˚ F
(24˚ C). This is a cooler warm rinse than you are
SPIN TIME DELAY
used to, but it saves energy and gives proper
rinsing. The load is a comfortable temperature
remove from the washer.
1. Wash/Rinse Temperature
• Water temperature can be selected as below
according to the program.
- SANITARY
HOT/COLD
- COTTON
WARM/COLD ➔ WARM/WARM➔HOT/COLD ➔
TAP COLD/COLD ➔ COLD/COLD
- PERM. PRESS
WARM/COLD➔WARM/WAR➔TAP COLD/COLD➔COLD/COLD
- WOOL/SILK & RINSE+SPIN
COLD/COLD ➔ WARM/COLD ➔
WARM/WARM➔TAP COLD/COLD
Selected temperature's lamp turns on.
For the more detailed information, please refer to the page12.
Temperature Guide
Wash Water Temperature
Hot
111˚ F (44˚ C) or above
Warm
90˚-110˚ F (32˚- 43˚ C)
Cold
70˚-90˚ F (21˚-32˚ C)
In wash water temperatures colder than 70˚ F (21˚ C),
detergents do not dissolve well. Soils may be difficult to
remove.
1400
1000 HOT/COLD
800
WARM/WARM
DRY ONLY
400
WARM/COLD
NO SPIN
EXTRA RINSE
COLD/COLD

RINSE HOLD

EXTRA WASH
TAP COLD/COLD
SPIN
OPTION
TEMP.
SPIN
START/PAUSE
Suggested Fabrics
Whites and pastels
Heavy and greasy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
• By pressing the SPIN button,
1400
the spin rpm can be chosen.
HOT/COLD
1000
TIME LEFT
800 WARM/WARM
-RINSE HOLD
400
WARM/COLD
AUTO DRY
NO SPIN
- NO SPIN
COLD/COLD
RINSE HOLD
TIME DRY
TAP COLD/COLD
- 400
- 800
SPIN
TEMP.
TIME DELAY
DRY
-1000
-1400
1. Spin selection
• Spin rpm is available according to the program as
follows.
START/PAUSE
TIME DELAY
[Wash Programs]
- SANITARY & COTTON & RINSE+SPIN
800➔1000➔1400➔Rinse Hold➔No Spin➔400
- PERM. PRESS
800➔1000➔Rinse Hold➔No Spin➔400
- WOOL/SILK
400➔800➔1000➔Rinse Hold➔No Spin
[Wash/Dry Programs]
- SANITARY & COTTON & RINSE+SPIN
1400➔800➔1000
- PERM. PRESS
1000➔ 800
2. No spin
• If NO SPIN is selected, the washer stops
after draining water.
The required lamp will light up for
identification.
3. Rinse Hold
• Is selected by pressing the SPIN button
repeatedly this function leaves clothes in the
washer; suspended in the water after a rinse
without entering into spin.
• To proceed through to a drain or spin,
once the rinse hold function is completed
using to program dial scroll to the required
program. (Spin or Pump)
The required lamp will light up for identification.
SPIN
WASH
RINSE
SPIN
TIME LEFT
DRY
AUTO DRY
DOOR LOCK
START/PAUSE
TIME DRY
WASH RINSE+SPIN
WOOL/SILK
TIME DELAY
PERM. PRESS
COTTON
SANITARY
WASH
RINSE
SPIN
DRY
DOOR LOCK
START/PAUSE
DRY
15