Stacking Kit Installation - LG WM2455H User's Manual & Installation Instructions

O P T I O N A L AC C E S S O R I E S
STACkING kIT
This stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
Tools Needed for Installation:
• Phillips-head screwdriver

STACkING kIT INSTALLATION

Make sure the surface of the washer is clean
1
and dry. Remove paper backing from the
tape on one of the stacking kit side brackets.

MFL31245113_ENG.indd 36-37
To ensure safe and secure installation, please
observe the following instructions.
wWARNING
• Incorrect installation can cause serious
accidents.
• The weight of the dryer and the height of
installation make this stacking procedure
too risky for one person. Two or more
people are required when installing the
stacking kit. There is a risk of serious back
injury or other injuries.
• Do not use the stacking kit with a gas dryer
in potentially unstable conditions such as a
mobile home. Failure to follow this warning can
result in serious injury.
• Place the washer on a solid, stable, level
floor capable of supporting the weight of
both appliances. Failure to follow this warning
can result in serious injury.
• Do NOT stack the washer on top of the dryer.
Failure to follow this warning can result in
serious injury.
• If appliances are already installed,
disconnect them from all power, water, or
gas lines and from draining or venting
connections. Failure to do so can result in
electrical shock, fire, explosion, or death.
Fit the side bracket to the side of the washer
2
top as shown in the above illustration. Firmly
press the adhesive area of the bracket to the
washer surface. Secure the side bracket to
the washer with a screw on the back side of
the bracket. Repeat steps 1 and 2 to attach
the other side bracket.
O P T I O N A L AC C E S S O R I E S
STACkING kIT INSTALLATION
(cont.)
Dryer
Washer
Place the dryer on top of the washer by
3
fitting the dryer feet into the side brackets as
illustrated. Avoid finger injuries; do not allow
fingers to be pinched between the washer
and dryer. Slowly slide the dryer toward the
back of the washer until the side bracket
stoppers catch the dryer feet.
Insert the front rail between the bottom of
4
the dryer and the top of the washer. Push the
front rail toward the back of the washer until it
comes in contact with the side rail stoppers.
Install the two remaining screws to secure the
front rail to the side rails.

2007.10.4 2:32:14 PM