To prevent injury or fire, take the following
Stop the car before operating the unit.
To prevent a short circuit, never put or leave any
metallic objects (such as coins or metal tools) inside
Adjust the volume so that you can hear sounds
outside the car. Driving with the volume too high
may cause an accident.
Wipe off the dirt on the panel with a dry silicon or
Failure to observe this precaution may result in
damage to the monitor or unit. "
When the car is air-conditioned, moisture may collect
on the laser lens. This may cause disc read errors. In
this case, remove the disc and wait for the moisture to
If you experience problems during installation,
consult your Kenwood dealer.
When you purchase optional accessories, check with
your Kenwood dealer to make sure that they work
with your model and in your area.
Characters that conform to ISO 8859-1 can be
About discs used with this unit
This unit can only play the CDs with
The following discs cannot be used:
- Discs that are not round
- Discs with coloring on the recording surface or
discs that are dirty
- Recordable/Rewritable disc that has not been
finalized (For the finalization process, refer to
your disc writing software, and your disc recorder
- 8 cm (3 inch) disc (Attempt to insert using an
adapter can cause malfunction.)
Do not touch the recording surface of the disc.
Do not stick tape etc. on the disc, or use a disc with
tape stuck on it.
Do not use any accessories for the disc.
Do not use any solvents to clean discs. Use a dry
silicon or soft cloth.
Clean from the center of the disc and move outward.
When removing discs from this unit, pull them out
Remove the rims from the center hole and disc edge
before inserting a disc.
How to reset your unit
If the unit fails to operate properly, press the Reset
button. The unit returns to factory settings.
English | 3