Panasonic WV-CP500 Installation Manual page 19

n
Turn on the power.
WV-CP500
The included power cord is connected to this power connector.
Connect between the power connector on the rear side of the camera and a plug socket with
the supplied power cord.
220 to 240 V AC,
50 Hz
Caution:
• The camera shall be connected with cord set with plug.
Plug for respective country shall be mounted on the Power
cord by a qualified electrical.
WV-CP504
Important:
• The power supply of 24 V AC/12 V DC shall be
insulated against 220 to 240 V AC.
• The power supply is automatically select-
ed either 24 V AC or 12 V DC. No setting is
required with this camera.
q Loosen the screw of the power cord plug
(accessory).
w Connect the power supply (option) of 24 V AC
or 12 V DC to the power cord plug.
Strip the end of the wire by 3 mm to 7 mm, and
twist the stripped part of the wire sufficiently to
avoid short circuit.
• Specification of cable (wire)
AWG #16 - #28, Single core, twisted
* Check whether the stripped part of the wire
is not exposed and is securely connected.
<Ratings>
24 V AC
A 2-N
B GND
C 1-L
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the AC/DC
power terminal on the rear side of the camera.
* Make sure that the power cord plug is inserted fully into the AC/DC power supply terminal.
Power cord (accessory)
12 V DC
@ (GND)
NC
!
ALARM OUT POWER
GND
ALARM IN
220 - 240 V ~ 50Hz
ALARM OUT GND
VIDEO OUT
POWER
ALARM IN
(UP)
NEAR BF/MENU
FAR
~
24V IN
1-L 2-N
(RIGHT)
(LEFT) (SET)
GND
(DOWN)
12V IN
NC
To 24 V AC/12 V DC
power supply
Power cord plug
(accessory)
Stripped
3 mm - 7 mm
VIDEO OUT
19