16-34 ELECTRICAL SYSTEM
Using a cleaning fluid, clean off any oil or dirt on the
washer [A] and dry it with a clean cloth.
Install the washer.
Confirm the alternator rotor fit or not to the crankshaft
before tightening it with specified torque.
Install the rotor bolt [B] and tighten it with 70 N·m (7.0
kgf·m, 52 ft·lb) of torque.
Remove the rotor bolt and washer.
Check the tightening torque with flywheel puller [A].
Special Tool - Flywheel Puller Assembly, M38 × 1.5/M35 ×
If the rotor is not pulled out with 20 N·m (2.0 kgf·m, 15
ft·lb) of drawing torque, it is installed correctly.
If the rotor is pulled out with under 20 N·m (2.0 kgf·m, 15
ft·lb) of drawing torque, clean off any oil dirt or flaw of the
crankshaft and rotor tapered portion, and dry them with
a clean cloth. Then, confirm that it is not pulled out with
Install the washer and rotor bolt.
Tighten the alternator rotor bolt [A] while holding the alter-
nator rotor steadily with the holder [B].
Special Tools - Grip [C]: 57001-1591
Rotor Holder: 57001-1666
Stopper [D]: 57001-1679
Rotor Holder Attachment: 57001-1689
Torque - Alternator Rotor Bolt: 155 N·m (15.8 kgf·m, 114
Install the alternator cover (see Alternator Cover Installa-