Apply plenty of grease to the lip of the oil seals [A].
Be sure to install the oil seals and sleeve [B] to the
Fit the collar [C] on the oil seal of the left side.
Screw the adjusting collar [A] into the frame [B] so that the
collar does not project the swingarm mating surface [C].
Insert the swingarm pivot shaft [A] into the adjusting collar
[B] from the right side, and tighten the pivot shaft.
Tighten the swingarm pivot shaft until the clearance [C]
between the ball bearing [D] and collar come to 0 mm
Torque - Swingarm Pivot Shaft: 20 N·m (2.0 kgf·m, 15 ft·lb)
Using the swingarm pivot nut wrench, tighten the
swingarm pivot adjusting collar locknut [E].
Special Tool - Swingarm Pivot Nut Wrench: 57001-1597
Torque - Swingarm Pivot Adjusting Collar Locknut: 98 N·m
(10.0 kgf·m, 72 ft·lb)
Tighten the swingarm pivot shaft nut.
Torque - Swingarm Pivot Shaft Nut: 108 N·m (11.0 kgf·m,
Install the removed parts (see appropriate chapters).
Swingarm Bearing Removal
Swingarm (see Swingarm Removal)
Oil Seals [B]
Circlip [D] (Right Side)
Special Tool - Inside Circlip Pliers: 57001-143