External Shift Mechanism
Shift Pedal Removal
Shift Lever Bolt [A]
Shift Lever [B]
If the tie-rod is removed from the shift pedal and shift lever,
note the following.
The following portions have left-hand threads.
Shift Lever Side of Tie-Rod
Locknut [C] of Shift Lever Side
Ball Joint [D] of Shift Lever
Shift Pedal Mounting Bolt [E]
Tie-Rod [F] and Shift Pedal [G]
Shift Pedal Installation
Apply grease to the sliding surface [A] on the shift pedal
mounting bolt [B].
Apply a non-permanent locking agent to the threads of
the shift pedal mounting bolt.
Tie-Rod [D] and Shift Pedal [E]
Torque - Shift Pedal Mounting Bolt: 25 N·m (2.5 kgf·m, 18
Align the punch mark [A] on the shift shaft with the slit [B]
of the shift lever.
Tighten the shift lever bolt.
After installation, confirm that the shift pedal [C] is posi-
tioned as shown.
About 86° [D]
About 91° [E]
0 ∼ 2 mm (0 ∼ 0.08 in.) [F] (The distance between the
center line of the tie-rod [G] and center in the shift pedal
If the pedal position is different, adjust it as follows.
To adjust the pedal position, loosen the front locknut [H]
(left-hand threads) and rear locknut [I], and then turn the
Tighten the locknuts securely.
External Shift Mechanism Removal
Shift Lever (see Shift Pedal Removal)
Clutch (see Clutch Removal in the Clutch chapter)
Special Tool - Outside Circlip Pliers: 57001-144