5-44 ENGINE TOP END
Exhaust Butterfly Valve Cable Installation
Confirm whether pulley [A] is an angle shown.
41.7° ±7° [B]
This position is original position of the pulley.
Correct the position electrically after confirming use is
discontinued and there is no damage when differing
from the angle of shown.
Do not correct the pulley position with the tool,
forcibly. The actuator damage will occur.
If the angle is wrong, adjust the pulley (see Exhaust But-
terfly Valve Actuator Installation in the Self-Diagnosis Sys-
Run the exhaust butterfly valve cables correctly (see
Cable, Wire, and Hose Routing section in the Appendix
Install the lower ends of the exhaust butterfly valve cables
to the pulley of the muffler body as shown.
Open Cable [A] (White Locknut)
Close Cable [B] (Black Locknut)
Torque - Exhaust Butterfly Valve Cable Locknuts [C]: 5.0
N·m (0.51 kgf·m, 44 in·lb)
Fit the slot [A] of the muffler cover [B] to the damper [C]
of the muffler body, and tighten the bolts.