Led Indicator - Motorola AP-6521E Installation Manual

Installation Guide
9. Place the decal on the back of the badge and slide the badge onto the light pipe from the finished side of
the tile.
10. Attach the antennas to their correct connectors.
11. Align the ceiling tile into its former ceiling space.
12. Cable the Access Point using either the Power Injector solution or an approved line cord and power supply.
CAUTION
For Motorola Power Injector installations:
a. Connect an RJ-45 CAT5 Ethernet cable between the network data supply (host) and the Power
Injector's Data In connector.
b. Connect an RJ-45 CAT5 Ethernet cable between the Power Injector's Data & Power Out connector
and the Access Point.
c. Ensure the cable length from the Ethernet source (host) to the Power Injector and Access Point does
not exceed 100 meters (333 ft). The Power Injector has no On/Off power switch. The Power Injector
receives power as soon as AC power is applied. For more information, see
For power adapter (Part Number PWRS-147376-01R) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and the
Access Point's GE1/PoE.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable to the DC-48V power connector on the Access Point.
e. Attach the power supply line cord to a power supply.
13. Verify the behavior of the Access Point LED light pipe. For more information, see
LED Indicator.
14. Place the ceiling tile back in its frame and verify it is secure.
15. The Access Point is ready to configure. For information on basic Access Point device configuration, see
Basic WiNG Express Access Point Configuration
Do not connect to the power source until the cabling of the Access
Point is complete. Ensure PoE is not connected to the Access Point's
console connector or risk rendering the console connector
permanently inoperable.
.
Power Injector System
17
.