Replacing The Lamp - LG AN110B-JD Owner's Manual

Replacing the Lamp

Last of Lamp unit replacement
The projector lamp usually lasts for about 4000 hours. You can see the used lamp
time in the Selecting Function section. You must replace the lamp when:
The projected image gets darker or starts to be deteriorated.
G
The lamp indicator is red.
G
The message "Replace the lamp" appears on the screen when turning the
G
projector lamp on.
Be careful when replacing lamp
- Press the POWER button on the control panel or remote control to cut off the power.
- If the operation indicator LED is orange and blinking, do not disconnect the mains supply until the operation indicator LED
is lit up constantly (orange).
- Allow the lamp to cool for 1 hour before replacing it.
- Replace only with the same type lamp from a LG Electronics Service Center using and other lamp
may cause damage to the Projector and lamp.
- Pull out the lamp only when replacing the lamp.
- Keep the lamp unit out of reach of children or and heat sources such as radiators, stoves.
- To reduce the risk of fire, lamp shall not be exposed to liquids or foreign material.
- Do not place the lamp near any heat source.
- Make sure the new lamp is securely tightened with screws. If not, the image may be dark or there could be a risk of fire.
- Never touch the lamp unit glass or otherwise image quality may be worse or lamp life may be reduced.
To obtain a replacement Lamp unit
Lamp model number is on page 47. Check the lamp model and then purchase it at LG Electronics Service Center.
Using other lamp may cause damage to the projector.
Lamp unit disposal
Dispose of the used lamp by returning it to the LG electronic service center.
<Front panel of the Projector>
Lamp indicators
Information
43