Ignition Control - Ignition Off; Thor Vm2 Is Off And Vehicle Ignition Is Off; Thor Vm2 Is On And Vehicle Ignition Is Switched To Off - Honeywell THOR VM2 Reference Manual

Ignition Control - Ignition Off

Select either the Ignition Control - Ignition On or the Ignition Control - Ignition Off power scheme when ignition control of the
Thor VM2 power on process is desired.
The Thor VM2 automatically switches between the Ignition Control - Ignition On or the Ignition Control - Ignition Off power
schemes depending on the state of the vehicle ignition input. Default timeouts are shorter in this scheme to conserve the
vehicle battery charge.
The following default timeouts are used in the Ignition Control - Ignition Off power scheme.
Plugged In
Setting (AC or DC
Turn off monitor 1 minute
Turn of hard disks 5 minutes
System standby
System hibernate
The ignition input wire must be connected. If the user selects this power scheme but the ignition is On, the Ignition Control -
Ignition On scheme is used instead.
When either Ignition Control Power Scheme is selected and external power is present the Thor VM2 behaves as described
below. If external power is not present, refer to the

Thor VM2 is Off and Vehicle Ignition is Off

Conditions
The Thor VM2 is Off and vehicle ignition is Off.
Result
The Thor VM2 remains Off regardless of external power. UPS charging is disabled.
Conditions
The Thor VM2 has external power but vehicle ignition is Off. The Power button is pressed.
Result
The Thor VM2 boots. Once booted the Thor VM2 follows the Ignition Control/Ignition Off power scheme with timers reset
after the boot completes.

Thor VM2 is On and Vehicle Ignition is Switched to Off

Conditions
The Thor VM2 is On and vehicle ignition changes from On to Off.
Result
Running on
Batteries
Power) (UPS Power)
1 minute
1 minute
1 hour 10 minutes
6 hours 20 minutes
UPS section for Thor VM2 behavior.
3-28