Pride Victory XL-4 Owner's Manual page 24

V . B A T T E R I E S
BATTERY REPLACEMENT
To change a battery in your scooter:
1. Power down your scooter and remove the key.
2. Remove the seat.
3. Gently lift the rear shroud off of your scooter
far enough to be able to disconnect the rear
lighting harnesses. See figure 12.
4. Disconnect the battery tie-down strap.
5. Disconnect the battery harness from the battery
mating plug. See figure 12A.
6. Disconnect the battery cables from the battery
terminals.
7. Remove the old battery.
8. Place a new battery in the battery well.
9. Connect the red battery cable to the positive (+)
battery terminal.
10. Connect the black battery cable to the negative
(-) battery terminal.
11. Reconnect the battery harness to the battery
harness mating plug. See figure 12A.
12. Reconnect the battery tie-down strap.
13. Reinstall the rear shroud and the seat.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.
BATTERY DISPOSAL AND RECYCLING
If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and call your authorised
Pride provider for instructions on disposal. Your authorised Pride provider will also have the necessary
information on battery recycling, which is our recommended course of action.
FREQUENTLY ASKED QUESTIONS (FAQ
How does the charger work?
When battery voltage is low, the charger works harder and sends more electrical current to the batteries to
bring up their charge. As battery voltage approaches a full charge, the charger sends less electrical current
to the batteries. When the batteries are fully charged, the current sent from the charger is at nearly zero
amperage. Therefore, when the charger is plugged in, it maintains the charge on your batteries but does not
overcharge them. We do not recommend that you charge your batteries for more than 24 consecutive hours.
Can I use a different charger?
For the safest, most efficient, and balanced charging of the batteries, you should simultaneously charge
both batteries using only the manufacturer-supplied onboard battery charger.
24
A N D C H A R G I N G
LIGHTING
HARNESSES
Figure 12. Disconnect Lighting Harnesses
BATTERY HARNESS MATING PLUGS
Figure 12A. Disconnect Battery Harnesses
)
S
BATTERY HARNESSES
Victory XL-4