D-Link DWL-120 User Manual page 38

TROUBLESHOOTING
HOW TO FREE AN IRQ
What to do if you don't have an available IRQ
continued
5. The next setting below should be "Reset
Configuration" or "Reset ESSCD." Set this to
"Enabled."
Note: This is a one-time setting. Meaning after
you reboot your computer the setting will return to
"Disabled." This setting allows Windows to recon-
figure all of the configuration information for your
Plug and Play hardware. It is reset to "Disabled" so
that Windows will not perform the reconfiguration
each time you start your computer.
6. "Save" the new settings and Exit your BIOS. This
will allow your computer to boot up and load Windows.
7. After Windows loads, check in the Device Manager to see if
there is an available IRQ.
34