Installing Door Handle; Toe Grille Removal - Electrolux E32AR85PQS Use & Care Manual

Door Handle
Mounting Instructions
1. Remove handle from carton and any
other protective packaging.
2. Position handle end caps over upper
and lower preinstalled shoulder bolts
(A) that are fastened into door.
3. While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
NOTE
All set screws should be tightened so the
screw is below the surface of the handle.
The handles should be drawn tight to
freezer and refrigerator doors with no gaps.
Opening the opposite door while tightening
the Allen screw makes installation easier.
The door handle may loosen over time or if
it was installed improperly. If this happens,
tighten the set screws on the handles.

Toe Grille Removal

To remove the toe grille, use a Phillips
head screwdriver and remove the 2
screws holding the toe grille to the cabinet.
Then pull the toe grille away from the unit.
Leveling
• The refrigerator must have all bottom
corners resting firmly on a solid floor.
• The floor must be strong enough to
support a fully loaded refrigerator.
• It is VERY IMPORTANT for your
refrigerator to be level in order to
function properly. If the refrigerator
is not leveled during installation,
the door may be misaligned and
not close or seal properly, causing
cooling, frost or moisture problems.

Installing Door Handle

Toe Grille
Remove
Screws
7