Unpacking Hd Dvr And Accessories/Connection Overview - LG LST-3410A Owner's Manual

Unpacking HD DVR and Accessories/Connection Overview

Make sure you have received all the accessories listed below with the HD DVR.
HDTV DIGITAL VIDEO RECORDER / RECEIVER (HD DVR)
This HD DVR is capable of receiving signals from cable and/or over-the-air antenna sources.
Included with the HD DVR are the following accessories.
Audio Cable/Video Cable/Component (YPbPr) Cable/G-LINK cable
Remote Control and 2 AA Batteries
10
Audio/Video Jacks and Cables
The Audio/Video jacks provide excellent picture and sound quality. They are
used for making most Audio/Video connections between components. The
Audio/Video jacks may be color coded (yellow for video, red for right audio,
and white for left audio). If your component has only one input for audio
(mono), connect it to the left (white L/mono) audio jack on the HD DVR.
Component Video Out Jacks and Cables
Component Video Cables are used to connect the HD DVR to an industry
standard YPbPr compatible HD Monitor (green for Y, blue for Pb, and red
for Pr). Remember to also connect the left and right audio cables. The
YPbPr Component jacks carry only the picture signals, not the sound.
DVI-HDTV port and Cable
DVI cable is used to connect the HD DVR to an industry standard DVI-
HDTV compatible HD monitor. A DVI jack carries only the video signals, not
the audio.
G-LINK cable
G-LINK Cable is used to control cable box with the TV Guide On Screen™
system.
TV Guide On Screen system Demo Pin and Tag
Demo Pin consists of a tag and rivet that restricts the TV Guide On Screen
system. Retail Demo feature contained in the HD DVR firmware.
You must remove the Demo Pin from the G-LINK jack and insert the IR
Controller in the G-LINK port. This disables the retail Demo feature and
allows normal Host device operation.
Remote Control
In addition to the HD DVR, the remote control can be programmed to
operate other IR controlled accessory devices.
Remote Control Operating Range
Point the remote control at the remote sensor and press the buttons.
Distance: About 23 ft (7 m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
Remote Control Battery Installation
Detach the battery cover on the rear of the remote control, and insert two
batteries (size AA) with and
Caution
Do not mix old and new batteries. Never mix different types of batteries
(standard, alkaline, etc.).
aligned correctly.