Fast Charging Of Lithium Battery - Skyrc Imax B6 Instruction Manual

FAST CHARGING OF LITHIUM BATTERY

Fast charging of lithium battery
NiCd Sensitivity
D.Peak Default
- -
+
DEC DEC
INC
Batt type
Start
'>3 seconds'
Stop
Enter
Start
Enter
NiCd Sensitivity
D.Peak Default
Suppiled
Charging
Number
capacity
time
of
Charge
cells
current
Charging lithium battery in the fast charge mode
Charging current will become lower when it progress to the end of charging. A specific CV
process will be reduced to end the charging process earlier. In fact, the charging current will
goes to 1/5 when the charging process comes to 1/10. Charging capacity will be little smaller
than normal charging, but charging time will be shortened accordingly.
The value on the left side of the second lines sets the charge
current. The value on the right side of the second lines sets the
battery pack's voltage. After setting current and voltage, press
STAR/ENTER for more than 3 seconds to start the process.
+
INC This displays the number of cells you set up and the processor
detects. "R" shows the number of cells detected by the charger and
"S" is the number of cells set by you at the previous screen. If both
n u m b e r s a r e i d e n t i c a l y o u c a n s t a r t c h a r g i n g b y p r e s s
START/ENTER button. If not, press BATT TYPE/STOP button to go
back to previous screen to carefully check the number of cells of
the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.
Current
voltage
battery
18