Wall Mounting - Panasonic KX-HNC200 Installation Manual

Wall mounting

R Mount the camera on the stable location
where the unit can be adequately
supported when installing.
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
R Do not mount the camera on a soft
material. It may fall down, break or cause
injury.
R Do not mount the camera on the following
places: plaster board, ALC (autoclaved
lightweight cellular concrete), concrete
block, plywood less than 25 mm (1 inch)
thick, and etc.
1
Drive the screws (not supplied) into the
wall.
1
Longer than 20 mm (25/32 inches)
2
Space 1.3 mm (1/32 inches)
1
Note:
R Use the following template when
determining the location of the screw
holes.
(1 3/32 inches)
For assistance, please visit www.panasonic.com/support
2
28 mm
2
Mount the camera to the wall.
1
Screws
2
28 mm (1 3/32 inches)
3
Adjust the angle of the camera.
Setup
2
1
11