TABLE OF CONTENTS Introduction / Operation Notes Features Panel Descriptions Connecting and Operating the 4X1 Switcher For HDMI 1.3 RMT4-IR Installation IR Code Conflicts RS-232 Serial Control Interface Wiring Diagram Specifications Warranty...
INTRODUCTION The Linear 4x1 Switcher for HDMI 1.3 routes high definition video in multiple resolutions up to 1080p plus multichannel digital audio from any of four sources to one display. Four HDMI inputs accommodate the simultaneous connection of up to four high definition video sources, such as satellite systems, Blu-ray and HD-DVD players.
FEATURES Features • Switches easily between any four HDMI sources • Supports resolutions up to 1080p, 2K and 1920 x 1200 • Inputs can be switched with the IR remote control, the selector buttons on the front of the unit, or by RS-232 serial control interface •...
PANEL DESCRIPTIONS FRONT IR Eye Input LED Input 1 Input 3 Power LED Indicator Selector Selector Indicator Input 2 Input 4 Selector Selector BACK Input 1 Input 2 Input 3 Input 4 RS-232 Control Port 5V DC Power Input IR Eye Extension Port DIP SWITCH LOCATION 4 Bank Dip...
CONNECTING AND OPERATING THE 4X1 SWITCHER FOR HDMI 1.3 How to Connect the 4X1 Switcher For HDMI 1.3 to your devices Connect the HDMI sources to the 4X1 Switcher for HDMI 1.3 input ports using the supplied HDMI cables. Connect the display (monitor or projector) to the 4X1 Switcher for HDMI 1.3 output port using a user supplied cable.
These actions will cause the remote to reset and steps 1-4 will have to be repeated. Note: The RMT-4IR ships with two batteries. Only one battery is required for operation, the other battery is complimentary. The optional IR extender allows you to relocate your HDMI Switcher and still retain IR control. Linear part# IR-EXTENDER...
IR CODE CONFIGURATION How to Resolve IR Code Conflicts In the event that IR commands from other remote controls conflict with the supplied RMT-4IR remote control, changing the remote channel will alleviate this issue. The RMT-4IR remote control and the 4X1 Switcher for HDMI 1.3 have DIP SWITCHES for configuring the remote channel that both units use to communicate.
SPECIFICATIONS Video Amplifier Bandwidth ................340 MHz Input Video Signal ..................1.2 volts p-p Input DDC Signal ................5 volts p-p (TTL) Single Link Range .........1080p/60 10 bit color depth, 1920x1200 HDMI Connector ...............Type A 19 Pin Female Remote Control Port ..............RS-232, mini-stereo Power Supply ....................5V DC Power Consumption ................10 watts (max) 13.25”W x 1”H x 2.75”D...
This Linear LLC Warranty is in lieu of all other warranties express or implied. Some states and countries do not allow limitations or how long an implied warranty lasts or the exclusion or limitation or incidental or consequential damages, so the above exclusions may not apply.
Page 16
H DMI -S W- 4X 1 (7 6 0) 4 38 - 7 0 0 0 ( 80 0 ) 4 2 1-15 87 FA X ( 8 0 0 ) 4 6 8 - 13 4 0 www. li ne arc o r p . c o m Re v A...
Need help?
Do you have a question about the HDMI-SW-4X1 and is the answer not in the manual?
Questions and answers