Other Error Messages - Canon MG 5600 Series Online Manual

• Printing does not start even though the port named "CNBJNP_xxxxxxxxxx" is selected when the
machine is used over LAN:
Launch IJ Network Tool, and select "CNBJNP_xxxxxxxxxx" as you confirmed in step 4, then
associate the port with the printer using Associate Port in the Settings menu.
If the problem is not resolved, reinstall the MP Drivers with the Setup CD-ROM or install them from
our website.
Make sure that the machine is connected to your computer properly.
Check3
When the machine is connected to your computer with a USB cable, make sure that the USB cable is securely
plugged in to the machine and the computer, then check the followings:
• If you are using a relay device such as a USB hub, disconnect it, connect the machine directly to the
computer, and try printing again. If printing starts normally, there is a problem with the relay device.
Consult the reseller of the relay device for details.
• There could also be a problem with the USB cable. Replace the USB cable and try printing again.
When you use the machine over LAN, make sure that the machine is set up to be used over network correctly.
Make sure that the MP Drivers are installed correctly.
Check4
Uninstall the MP Drivers following the procedure described in
reinstall the MP Drivers with the Setup CD-ROM or reinstall them from our website.
When the machine is connected to your computer with a USB cable, check
Check5
the status of the device on your computer.
Follow the procedure below to check the status of the device.
1. Open the Device Manager on your computer as shown below.
If the User Account Control screen is displayed, follow the on-screen instructions.
• In Windows 8.1 or Windows 8, select Control Panel from the Settings charm on Desktop >
Hardware and Sound > Device Manager.
• In Windows 7 or Windows Vista, click Control Panel, Hardware and Sound, then Device Manager.
• In Windows XP, click Control Panel, Performance and Maintenance, System, then click Device
Manager on the Hardware sheet.
2. Double-click Universal Serial Bus controllers then USB Printing Support.
If the USB Printing Support Properties screen is not displayed, make sure that the machine is correctly
connected to the computer.
Make sure that the machine is connected to your computer properly.
Check3
3. Click the General tab and make sure that there is no indication of a problem with the device.
If a device error is displayed, refer to Windows help to resolve the error.

Other Error Messages

If an error message is displayed outside the printer status monitor, check the
Check
following:
• "Could not spool successfully due to insufficient disk space"
Delete any unnecessary files to increase the amount of free space on the disk.
Deleting the Unnecessary MP
817
Drivers, then