Answering Reception Mode - Sanyo SFX-30 Instruction Manual

31
Answer reception mode
—
—
Use this mode if you want to receive both phone messages and faxes while
you are away. (Connect an answering machine to the SFX-30 through the line
cord supplied with the SFX-30 or by the SANYO Dealer.)
1
The telephone rings according to the ring delay setting of your
answering machine.
When an
incoming
fax signal is received:
The SFX-30 automatically switches to the receiving mode.
When a phone call is received:
The built-in phone rings and the connected answering machine plays your
announcement and then takes messages.
The SFX-30 can receive a fax after the answering machine plays the announce-
ment if the caller is trying to send a fax manually.
If there is no incoming voice signal for 6 seconds, the SFX-30 automatically
switches over to the fax receiving mode and sends a fax signal to the caller.
Be sure to advise callers in your announcement that fax reception takes
place after the message.
Example: Please leave a message or send a fax after you hear the tone.
.E
2 -']
Fax
reception starts.
** RECEIVING **
3
Reception is completed.
26 Ott.'93 12:00
The answering machine must be set to answer a call within 10 rings. (If the
telephone is allowed to ring more than 11 times, the SFX-30 switches to fax
receiving mode.)
Automatic switching may not function properly on certain answering systems.
When the SFX-30 is set to the ANSWER mode, there maybe some difficulties
in remote message retrieval operation of the connected answering machine.
If you need to access the answering machine by remote, the SFX-30 must
be set to the MANUAL mode.