LG GCC-4480B Owner's Manual page 11

DirectCD v2.5b(s)
TM
Installation
The CD-RW/DVD-ROM drive connects to the motherboard of the host
computer using an IDE interface cable. You may connect the CD-RW/DVD-
ROM Drive as a Slave or Master device, depending on your computer.
To install the drive as a Master, the jumper can be left as supplied from
the factory.
Master drive
(Booting hard disk)
Primary
connector
Master drive
(Booting hard disk)
Primary
connector
NOTE : A hard disk is normally installed as the Primary Master on the
EIDE (ATAPI) interface. Other EIDE peripheral devices such as hard
drives and CD-RW/DVD-ROMs are then set differently.
8
Master drive
(CD-RW/DVD-
ROM drive)
(Jumper left as
MAster)
Motherboard
Secondary
connector
- OR -
Master drive
(CD-RW/DVD-
ROM drive)
(Jumper left as
MAster)
Slave drive
(Other IDE drive)
Secondary
connector