Sharp Aquos LC-32D43U Operation Manual page 18

Watching TV
You can change channels in several ways.
J1
- VOL
+
POWER
Method 1
Using CH A/Von the remote control unit or on the
TV.
Method 2
CD
Press
FLASHBACK
to switch to the previously
tuned channel.
®
Press FLASHBACK again to switch back to the
currently tuned channel.
TV
TV VCR AUDIO
goo
0
'I'1~p.
CBLlSAT DVD
FUNCTION
pO 0 0 0
SOURCE
LIGHT
S
8 @)
8
G 8
REC
0 0 GO
8 8
@ID
MODE
INPUT FLASHBACK
o
• FLASHBACK will not work if no channel has been
changed after the 1V is turned on.
Method 3
Using remote control buttons 0-9, • (DOT) to select
channels for VHF/UHF/CATV/OIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5---7ENT
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter
0-9
only, channel selection will be made if
there is no operation within a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
VOL
SURROUND
j+)
oU
CH
MUTE
o
Press 1---71 ---75
FREEZE MENU
O~o
8s8
EXIT
~RETURN
O~o
- FAVORITE CH -
@@@@
AQuas
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 ---72---7 • (DOT) ---71---7ENT
• When you enter 0-9 only, channel selection will be made if
there is no operation within a few seconds.
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter 0-9 and • (OOT) , channel selection will be
made if there is no operation within a few seconds.
@-17